Navigation
New forum topics
Syndicate
Posts from elsewhere
How to set iBlue 747 ProS to 5 Hz?
I bought a iBlue 747 ProS, but to set the mode to 5 Hz mogub not all the time is displayed 30 seconds. Already don `t know what to do, all other settings are correct accents. How to set for 5 seconds?
Hi There are two settings: 1)
Hi
There are two settings:
1) Determining the position @5Hz;
2) Logging the position @5Hz.
So you need to set to 'Fix every 200ms' and 'Log every 0.2 seconds' or use a distance or speed logging condition that is small enough for your interest.
Can you send some
Can you send some screenshots?
Hi I am not near to a logger
Hi
I am not near to a logger right now, but you can have a look at the screenshot here:
http://www.bt747.org/book/device-settings-panel
In stead of 500 ms you write 200 and for Log every .. seconds you put 0.2 and then click set.
In fact of the matter, I can
In fact of the matter, I can not change the 30 seconds when you disconnect from the program, setting up a 5 or 0.2 seconds, cleared completely, and is presented again for 30 seconds
I am having the same problem
I am having the same problem with an i-Blue 821E. Everytime I power cycle it, it reverts to "Time 30 seconds" in "Log by..." I was able to enable "Distance 1.0 m" and it seems to be persisting. I contacted the vendor (Semsons). They said BT747 was "too old" and said to use the manufacturer's Windows-only software. I'm tried both the stable and dev versions of BT747.
I'd really like to get this to work.
thanks,
glenn
Post new comment